ZBoost ALTE-AWS Betriebsanweisung PDF herunterladen (Seite 6)

zBOOST

SOHO DATABLAST™ UPGRADE USER GUIDE

zBOOST

SOHO DATABLAST™ UPGRADE USER GUIDE

IMPORTANT: Before Installing, Note These Important Factors in Determining

Performance:

zBoost DataBlast 4G signal booster extends a 4G Data Zone™ for multiple users/ devices. The

zBoost DataBlast upgrade system boosts data speeds by up to 20 times when integrated with your

existing cellular signal boosting system.

Important: By joining two signal boosters to a single exterior antenna, signal could be

reduced by as much as 3dB.

1. Atleast15vertical feetisneededbetweentheSignalAntenna(receivestheoutsidesignal)

andtheBaseUnitAntenna(rebroadcaststhesignalindoors).Separationlessthan15vertical

feetwillresultindecreasedperformance.

Iftheantennasaretooclosetogether,thelightontheBaseUnitwillashRED,indicatinga

problem-seetheBaseUnitLightIndicatorssection(page10).Tocapturethebestsignal,place

theSignalAntennaashighaspossible.

2. PositiontheSignalAntennaverticallyandkeepitatleast3feetaboveanymetal.

Cable Requirements

Your existing RG-59 or RG-6 cable should not exceed 50 feet. If the cable length exceeds 50 feet, it

should be replaced with RG-11. RG-11 should not exceed 100 feet. See the chart below.

A longer cable is helpful only if it allows you to place the Signal Antenna in a location where you

measure stronger signal.

Cable Recommended Length

RG-59 mini Up to 50 feet

RG-6 Up to 50 feet

RG-11 Up to 100 feet

Grounding the Signal Antenna

If the Signal Antenna is placed outdoors, it must be properly grounded. (See page iv for a

recommended grounding kit).

The setup must be in accordance with Article 810 of the National Electric Code (NEC). A listed

antenna discharge unit must be provided for the lead-in coaxial cable per NEC article 8.10.20 or the

shield of the coaxial cable must be permanently and effectively grounded in accordance with NEC

article 8.10.21. Please consult a professional installer or electrician for more information

Securing Cable with a Drip Loop

If the Signal Antenna is placed outdoors,

create a drip loop with the coaxial cable at

the point where the cable enters the building

through an outside wall. This can be done by

twisting and securing the cable into a loop

(no less than 4” across) near the entry point.

This will help prevent moisture from gathering

at entry point and leaking into the building.

Consult a professional installer for more

information.

Power Requirements

The Base Unit can be plugged into a standard 2 or 3 prong 110 VAC receptacle using the included

power supply. The power supply consumes less than 10W (less than 0.2A).For more information on

power consumption, see “Technical Specications” on page 11.

Warning

The zBoost SOHO DataBlast base unit MUST only be

used with the provided power adaptor. Use of other

power adaptors will void the warranty and may damage

the unit. Use of other equipment is not FCC approved.

Coax Cable

Exterior Wall

15’ of vertical

separation

15’ of vertical

separation

15’ of vertical

separation

OUT

PUT

CEL PCS

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

ZBoost ALTE-AWS Betriebsanweisung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Zelluläre Signalverstärker ZBoost ALTE-AWS